New reproduction Bosch 6 volt horn for 356 models.
This horn was taken from a set and only have this one in stock, that is it.
The horns are assembled here in the United States from a combination of imported and American components. The horns are so correct that individual pieces of the original horns will actually interchange.
We made 200 sets only, 60 are gone. They have perfect data badges and are correctly sold as a pair of low and high tone. They look and sound exactly as the originals. We will also now be including a new pair of the special thin cross section 10mm nuts that mount the horns to the original brackets.
The horns are made to the very highest quality possible and the finish is oven baked enamel inside and out. A rag soaked in lacquer thinner may be rubbed vigorously on the finish and will remain free of any trace of the finish. A few people asked about the screws around the primeter. The original horns had black round head slotted screws like I have used, this head design is not available today. Neither is the smaller bright finish screws that retain the data plate, the originals were chrome plated brass which did not hold up very well.
We also had these made for us in 404 stainless here in the US. This was VERY expensive.The stampings are exactly as the original, you can mount the original wire terminal block from your original horns though I can't imagine who would want to. The horns are supplied with new spade terminals and a pair of rubber boots that make the wiring absolutely weather proof.
644 635 101 06
644 635 111 06
Copyright © 2012-2018 Aase Sales. The names "Porsche", "Carrera" and any other trademarks of Dr. Ing. h.c. F. Porsche AG are used for identification purposes only.
Ecommerce Software by Shopify